project spotlight

Project: 5-7 Telegraph Road Pymble

ACSES Engineers designed a shoring and bulk excavation solution that extended four levels below 5-7 Telegraph Road Pymble as well as the superstructures.

Below are some site specs:

  • Two buildings over common basement carparking
  • Three below ground basements
  • Each Basement level is over 2100m2
  • 47 Residential Units

Utilising our finite element modelling capabilities, we significantly reduced the required shoring works at 5-7 Telegraph Road Pymble by designing an anchored pile and shotcrete wall to support the excavated face above the Class IV material, and then vertically cut the rock strata down to the bulk excavation level.

We also designed the crane base, without requiring piles, to bear directly on the Class IV material located higher than the final bulk excavation level. This shoring and bulk excavation solution designed by ACSES Engineers resulted in massive cost and time savings for South West Builders, who must be congratulated on successfully carrying out the detailed works.

Again using our FEM expertise, ACSES Engineers designed the superstructures as a concrete framed solutions made up of columns and walls using the Dincel Wall product wherever possible. This eliminated the need for traditional vertical formwork and resulted in further savings in time and cost for the builder. To partition the units, lightweight non-load bearing walls made from fibre cement (Hebel) and framed Gyproc were used.

The project was architecturally designed by Aleksander Design Group and ACSES Engineers are proud to be part of the Design Team and honoured to be the Project Structural Engineer for this development.

5-7 Telegraph Road Pymble Image 1

5-7 Telegraph Road Pymble Image 2

5-7 Telegraph Road Pymble Image 3

5-7 Telegraph Road Pymble Image 5

5-7 Telegraph Road Pymble Image 6

5-7 Telegraph Road Pymble Image 7

5-7 Telegraph Road Pymble Image 8

Here is the 3D Perspective.

5-7 Telegraph Rd Pymble 3D

Read more

Project Location: 35 Devlin Street Ryde

ACSES Engineers designed a shoring and bulk excavation solution that extended four levels below Devlin Street, one of Sydney’s busiest roads.

Site access was limited to only the single carriage laneway at the rear, and large tenanted commercial buildings either side of the development were supported on high-level foundations that needed to be protected as well. Utilising our finite element modelling capabilities, we significantly reduced the required shoring works by designing an anchored pile and shotcrete wall to support the excavated face above the Class IV material, and then vertically cut the rock strata down to the bulk excavation level. This resulted in massive cost and time savings for the builder YTO Constructions, who must be congratulated on successfully carrying out the detailed works. To further reduce construction time, we designed the superstructure as a concrete framed solution made up of columns and walls using the Dincel Wall product, which eliminated the need for traditional vertical formwork where ever possible. ACSES Engineers are proud to be part of the Design Team and honoured to be the Project Structural Engineer for this development.

35 Devlin Street Ryde

Here is the 3D Perspective.

35-37 Devlin St Ryde

Read more

Project Update: 100 Castlereagh Street Liverpool

Thanks for all the fantastic feedback.

Below are some site specs:

  • Four below ground basements
  • Each Basement is over 3300m2
  • 2 Commercial Levels
  • 25 Residential Levels – 298 Units

Here are some more images from the site:

100 Castlereagh Street Liverpool Image 1

100 Castlereagh Street Liverpool Image 2

100 Castlereagh Street Liverpool Image 3

100 Castlereagh Street Liverpool Image 4

100 Castlereagh Street Liverpool Image 5

100 Castlereagh Street Liverpool Image 6

100 Castlereagh Street Liverpool Image 7

100 Castlereagh Street Liverpool Image 8

100 Castlereagh Street Liverpool Image 9

100 Castlereagh Street Liverpool Image 10

100 Castlereagh Street Liverpool Image 11

Read more

Project Spotlight: 2A-8 Burwood Road Burwood

Shoring and bulk excavation works at 2A-8 Burwood Road Burwood have been completed and foundation works have begun. It’s a tight, detailed site, but the COPLEX Constructions team have everything running smoothly like a well-oiled machine. ACSES Engineers are proud to be part of the Design Team and honoured to be the Project Structural Engineer.

2A-8 Burwood Road Burwood Image 1

Here is the 3D Perspective.

2A-8 Burwood Road Burwood

Read more

Project Spotlight: 75-83 Second Avenue Campsie

Sheet Piles are in and bulk excavation works at 75-83 Second Avenue Campsie have now begun. Sam and the team at SWEDA have got it all under control and congratulations to Balintore Developments on yet another great project. ACSES Engineers are proud to be part of the Design Team and honoured to be the Project Structural Engineer for this development.

75-83 Second Avenue Campsie

Here are the 3D Perspectives.

75-83 Second Avenue Campsie Image 2

Read more

Project Spotlight: 76-80 Pemberton Street Parramatta

Concrete Structure works at 76-80 Pemberton Street Parramatta have progressed really well. Michael and his team at Conquest have done a great job once again. ACSES Engineers are proud to be part of the Design Team and honoured to be the Project Structural Engineer for this development.

76-80 Pemberton Street Parramatta

Here is the 3D Perspective.

Read more

Project Update: 153-165 Brougham Street Potts Point

Bulk excavation works at 153-165 Brougham Street Potts Point are coming to an end, and foundation works have begun. The crane is up and running and our ‘modified hybrid’ crane base design is working well. It’s a tight, detailed site, but the Reform team have everything well under control and moving like clockwork. ACSES Engineers are proud to be part of the Design Team and honoured to be the Project Structural Engineer.

153-165 Brrougham Street Potts Point

Here are the 3D Perspectives.

Read more

Project Spotlight: 316-320 Taren Point Road

Shoring and Bulk excavation works at 316-320 Taren Point Road Caringbah have been completed and construction of the super-structure is now well underway. Daniel and the team at ATB have got everything running like a well-oiled machine. ACSES Engineers are proud to be part of the Design Team and honoured to be the Project Structural Engineer for this development.

316-320 Taren Point Road Caringbah

Here are the 3D perspectives.


316-320 Taren Point Road image 2

Read more

Project Spotlight: 298-300 Taren Point Road Caringbah

Shoring and Bulk excavation works at 298-300 Taren Point Road Caringbah are proceeding as planned. The boys from A.C.E Civil are doing a great job. ACSES Engineers are proud to be part of the Design Team and honoured to be the Project Structural Engineer.

298-300 Taren Point Road Caringbah

298-300 Taren Point Road Caringbah

Here are the 3D perspectives.

298-300 Taren Point Road Caringbah 3d Perspectives

 

 

 

Read more

Project: 100 Castlereagh Street Liverpool

Shoring and Bulk excavation works at 100 Castlereagh Street Liverpool have been completed and construction of the super-structure is now well underway. Our shoring solution went down four levels and each basement footprint is just over 3350m2 each. The team from Ghossayn Group carried out the works with military precision and expertise and ACSES Engineers are proud to be part of the Design Team and honoured to be involved in such an excellent development.

100 Castlereagh Street Liverpool Image 1

Here is the 3D perspective.

Read more